This ‘base’ model features composite parts, used for the very first time on an Eclipse marker. The Feed tube, Eye Covers and Frame are manufactured from Glass Reinforced Nylon [GRN] a very durable material that is both tough and rigid. All other parts of the ETEK3 are manufactured from exactly the same materials with the finishes you will find on the Ego10 and SL range; high grade aluminum and stainless steel coupled with deep cosmetic and industrial hard anodizing.

Features

• LED Board - 3 tru-colour LED indicators
• Programmable Firing Modes – Semi Capped and Uncapped. Ramping Up To 22 BPS
• On/Off Purge System
• Break Beam Sensor System
• Fully Adjustable Trigger
• 14 inch 0 2-Piece Barrel – 2-Piece Micro Honed Etek3 14” length 0.693” Bore
• S3 Inline Regulator
• New Direct Mounted Solenoid
• Cure Bolt
• Zick Kit
• New Smaller Rammer Housing
• Deftek Offset Feed
• One-Piece Body (No FRM)

Dimensions

• Weight – 965g/2.12lb Including 14” Etek3 Barrel, Battery, Feed Tube, OOPS
• Length – 537mm Including 14” Etek3 Barrel
• Height – 208mm
• Width – 26mm

Materials

• Body – 6061-T6 Aluminum
• Barrel – 6061-T6 Aluminum
• Frame – Glass Reinforced Nylon
• Feed – Glass Reinforced Nylon
• Eye Covers – Glass Reinforced Nylon

Electronics

• Interface – Single Push Button plus Tourney Lock
• Solenoid voltage – 9Volts
• Processor voltage – 5 Volts
• Processor – 8-Bit 25MHz
• Power Supply – 1 x 9V (PP3) Battery

Hardware

• ASA Mount – T-Slot mounted adjustable rail with OOPS
• Trigger Methods – Micro Switch
• Trigger Mechanism – Magnetic Return
• Trigger Pivot – POM Self Lubricating Bearing Surface
• Feed Tube – Lever Operated Clamping Feed

Pneumatics

• Operating Principle – Under and Over Poppet
• Solenoid Type – SMC w/Custom Direct Mount Manifold

Ergonomics

• Grip Type – Contoured Dual Density Grip
• Grip Pitch – 151.4mm

Firmware

• Debounce Modes – 10 Debounce Modes
• Displays - None